2.Inputs
| No. | Name | Initialisation | Description |
|---|---|---|---|
| 1 | E1 PW in % | 0 | Percentage values from which the pulse width is calculated. |
| 2 | E2 Pulse width (sec.) | 0 | Calculation cycle in seconds. A zero as cycle time deactivates the controller |
| 3 | E3 On/Off | 0 | Switching on or off the module 1=switched on - 0=switched off |
3.Outputs
| No. | Name | Initialisation | SBC | Description |
|---|---|---|---|---|
| 1 | A1 (sbc) | 0 | sbc | Sends a 1 at the start of a cycle. After the pulse width expires, a zero is sent. A 1-bit value is output. |
| 2 | A2 falling (sbc) | 0 | sbc | Sends a 1 after the end of the pulse width. A 1-bit value is output. |
s = send, sbc = send by change
4.Other
| Recalculation during start: | Yes |
|---|---|
| Module is retentive: | No |
| Internal designation: | 9086 |
| Category: | Converter |