Time intervals are recorded here. These affect the updating (refreshing) of the user interface during operation.
Important
When selecting the intervals, it must be ensured that the updating can take place at the set interval!
For access with slow connections, e.g. via the Internet or mobile communications, a suitable refresh time must be selected!
The following settings refer to display with the browser or client program.
The following settings refer to display with the browser or client program.
Note
All of the following information are values in seconds!
Designation
This designation appears in the Refresh selection list of the Login mask.
It is used to select the optimum profile. This designation is only displayed in the HTML view.
It is used to select the optimum profile. This designation is only displayed in the HTML view.
Key
Each list entry must have a unique key.
This key is used in the client program for the update settings.
This key is also used to directly open the page in the browser.
Both parameters are described in the manual "Information on start-up".
This key is used in the client program for the update settings.
This key is also used to directly open the page in the browser.
Both parameters are described in the manual "Information on start-up".
Timeout
If no user activity or an automatic updating by the browser/client program takes place within the time set
here, then the HS/FS terminates the connection to this user.
here, then the HS/FS terminates the connection to this user.
Visualisation (without camera and without graph)
The visualisation page is automatically updated in this interval.
Neither a camera image nor a graph is located on the visualisation page.
Neither a camera image nor a graph is located on the visualisation page.
Visualisation with camera (without graph)
The visualisation page is automatically updated in this interval.
At least a camera image, however no graph, is located on the visualisation page.
IMPORTANT: It should be possible to load all camera images on a visualisation page in this time!
No moving image is shown on the visualisation page.
At least a camera image, however no graph, is located on the visualisation page.
IMPORTANT: It should be possible to load all camera images on a visualisation page in this time!
No moving image is shown on the visualisation page.
Visualisation with graph (without camera)
The visualisation page is automatically updated in this interval.
At least a graph, however no camera image, is located on the visualisation page.
IMPORTANT: It should be possible to load all graphs on a visualisation page in this time!
At least a graph, however no camera image, is located on the visualisation page.
IMPORTANT: It should be possible to load all graphs on a visualisation page in this time!
Visualisation All (with camera and with graph)
The visualisation page is automatically updated in this interval.
At least one camera image and at least one graph is located on the visualisation page.
IMPORTANT: It should be possible to load all cameras and graphs on a visualisation page in this time!
No moving image is shown on the visualisation page.
At least one camera image and at least one graph is located on the visualisation page.
IMPORTANT: It should be possible to load all cameras and graphs on a visualisation page in this time!
No moving image is shown on the visualisation page.
Camera
The Camera mask is automatically updated by the browser/client program at this interval if no streaming (see below) is active.
Masks
The masks (message archive, buddy list, camera archive) are automatically updated at this interval.
Streaming
Yes: This specifies that the camera image is shown as a moving image.
This option overrides the setting - Streaming in the Camera mask.
This option requires a high transmission speed (e.g. LAN).
Streaming is only supported with the client program.
It is advisable to switch on camera direct access in the user data.
This option overrides the setting - Streaming in the Camera mask.
This option requires a high transmission speed (e.g. LAN).
Streaming is only supported with the client program.
It is advisable to switch on camera direct access in the user data.